Inner diameter 3" Int.
Stainless steel AISI 316

Designed for attractions (can be reduced for the filter circuit)

Important information for installation:

This suction is designed for water attractions with a high flow rate (up to 88 m3/h). For safety reasons, it should always be installed in the number of min. 2 pcs per pump (attraction) - to avoid "sucking" the pool user.

If it is necessary to install only one piece of suction, it is possible to use suction up to a flow rate of 20 m3/h - when all openings on the grid are covered, suction can take place around the perimeter of the grid due to its protrusion.